18th Edition Wiring Regulations BS76712018 (City and Guilds 2382-18)

This City & Guilds 2382-18 – 18th Edition Course is essential for anyone who works or is involved with electrical installations, especially those who work within the domestic and commercial markets.

Description

This intensive 4 ½ day course is delivered in a classroom environment and is purely theory based. It will guide you through the IET Wiring regulations breaking down each topic into easy to understand modules.

Modules covered include

Scope, object and fundamentals
Definitions
Assessment of general characteristics
Protection for safety
Selection and erection of equipment
Inspection & testing
Special installations or locations

Prerequisites

There are no formal entry requirements for this course. As a general rule, candidates should have knowledge of electrical installation and electrical principles.

Similar courses

Basic Electrical Maintenance

On this course, you will learn to Identify and use basic electrical components. This course covers: • Isolating and testing supplies in line with the requirements of the EaWR and GS 38 • Using common electrical test instruments safely and efficiently • Reading typical electrical drawings • Reading motor rating plates • Identifying and connecting industrial motors

More Information

Basic Mechanical Maintenance

Delegates will learn the basic principles of Hydraulics Systems/ Mechanical devices Removing fitting and adjusting. This course covers: • Bearings: Recognise defects • Remove a range of plain, ball and roller bearings • Select and correctly fit a range of bearings • Belt and Chain drive mechanisms • Shafts and couplings including alignment • Drive Keys • Clutches and gear systems

More Information

Gas Cutting

You will learn and understand the safe use of gas cutting equipment

More Information

Introduction to Programmable Logic Controllers

The course will enable non electrical personnel to fault-find on systems incorporating PLCs, with up skilling which will save on down time and reduce unnecessary dependence on electrical staff. We can make this course bespoke for your business requirements.

More Information

Portable Appliance Testing (C&G 2377)

A 2 day course for those who are required to inspect and test electrical equipment in line with the IEE’s code of practice. Method of Delivery: • Lecture • Demonstrations • Practical exercises

More Information

Principles of Measurement and Metrology Techniques

A 1 day course covering the principles of measurement using a range of instruments commonly used in the Engineering industry. Method of Delivery: • Lecture • Demonstrations • Practical exercises There will be an assessment at the end which will require observation and questioning

More Information

PUWER 1998 Abrasive Wheels

A half day course to gain a full understanding of the legal duties as outlined within the Health and Safety at Work Act 1974, the Provision and Use of Work Equipment Regulations 1998 and follow the Health and Safety Executive guidance 17. Method of assessment: • Observation • Questioning

More Information

PUWER 1998 Part IV Power Press

A 1 day course to gain a full understanding of the legal duties as outlined within the Health & Safety at Work Act 1974 and the Provision and Use of Work Equipment Regulations 1998. Method of assessment: • Observation • Questioning

More Information

Welding Principles

Our welding principles course covers the practical and theoretical aspects of welding. Method of assessment: • Observation • Questioning

More Information